Pale Moon forum

It's very nice that http://linux.palemoon.org/download/installer/ shows the SHA-1 checksum and PGP signature on the page.

However, I do/check such so seldom that I never remember how to do so.

Could a corresponding link to how to do so, perhaps to somewhere within the FAQ, be added please?

I know it's simple (want to say 'mk5sum file checksum' and 'gpg -check somethingorother'), but I know that's wrong and the specifics completely escape me at the moment.

So a link, or even 2 or 3 lines of 'Check By:' on the page itself, would be very useful.

Thanks for listening.

Also ...

Adding 'try apt-get install libgtk2.0-0' to the yad error line would be useful.

If your distro has GtkHash available in the repository give it a try. I find it very quick and useful for checking a downloaded file.
Alternatively, you can use the command md5sum /pathtofile at the terminal to check just the md5 hash.

My point was ... put it on the page (please).

(As one is inherently on the command line, usually, if they're reading that bit, the non-gui version would be most immediately useful. To facilitate cut/paste, yup all is well ... proceed. Not to say the gui isn't useful, just not directly so, as a new thing, right then. Especially when one is in the middle of just trying to get a browser going. That's what they're focused on at that moment - anything else is a distraction that probably won't be paid attention to.)

Bumping around got me to https://www.whonix.org/wiki/Verify_the_ ... mmand_line. Didn't figure it out - knew I needed a key, etc., and ... well, see 'distraction' above.

In that bumping around, did find that 'shasum <filename>' did the trick. (Thanks for the md5summ - KNEW I should have been able to remember that. D'OH!)

No doubt there's a command line that will let shasum just say OK (or not), but didn't get that far. Focus just being getting a ^%*&%*&% browser going!