Page 1 of 1
"show source code for selection" produces an empty page
Posted: 2018-09-01, 21:41
by snotty
any site, any sort of marked text.
version 28.0.1
Re: "show source code for selection" produces an empty page
Posted: 2018-09-01, 21:49
by satrow
Thanks for confirmation, I noticed the same a while ago.
Re: "show source code for selection" produces an empty page
Posted: 2018-09-01, 23:13
by gepus
----- Confirmed.
Re: "show source code for selection" produces an empty page
Posted: 2018-09-02, 06:00
by Moonchild
Already
known, already fixed on trunk.
Issue #711 (UXP)
Re: "show source code for selection" produces an empty page
Posted: 2018-09-02, 12:49
by therube
Re: "show source code for selection" produces an empty page
Posted: 2018-09-17, 12:33
by 29 Skidoo
Is there an approximate ETA on when this will roll out in the regular distribution version? (FWIW, running 64-bit Windows version of PM (28.0.1)
Re: "show source code for selection" produces an empty page
Posted: 2018-09-18, 06:06
by Moonchild
Approximate ETA for the next normal update: This week.
Re: "show source code for selection" produces an empty page
Posted: 2018-09-19, 19:30
by 29 Skidoo
Thanks!8901234567